- Formed precisely to fit as the Harley Davidson Motor Company originally engineered.

- Proper gauge and correct alloy steel has been bent with no wrinkles or distortion.

- Centers between sidebar and engine case as designed.

- Pipe inlet interference fitment with cast iron cylinder outlet is superb.

- Saddle joint is formed as factory original with stop detents to properly support rear cylinder down tube and is spot weld securely.

- Inside saddle joint connection on main pipe has been properly excavated for no restriction exhaust gas flow.

- Outlet expansion joint has correct inside diameter for proper tolerance and muffler fitment.

- Outlet of header has slight upward cant to allow proper alignment of muffler.

- Supplied with correct over the brake cross shaft rear hanger.

- NO hammer OR pry bar necessary for installation.

- NO alterations needed.  NO hideous welds.  Almost installs itself!

- Top quality replacement part for your vintage American motorcycle.

- Supplied in bare/raw steel